Brooklyn Outdoor Pendant: Installation Tips

Quick answer

Install the Brooklyn Outdoor & Bathroom Pendant by first turning off power, then mounting the bracket, wiring the fixture, and sealing the canopy for weather resistance. Always use a GFCI circuit for outdoor or bathroom locations.

Installation steps

1. Turn off power and test: Switch off the circuit breaker for the installation area. Use a voltage tester to confirm no power is present at the junction box before touching any wires. Never skip the voltage test – even if the switch is off, the box may still be live.
2. Mount the bracket: Attach the supplied mounting bracket to the junction box using the provided screws. Ensure the bracket is level and securely fastened. For outdoor boxes, use silicone sealant around the screw holes to prevent water ingress. Check that the bracket is rated for the weight of the pendant (the Brooklyn pendant weighs about 2.5 lbs).
3. Wire the fixture: Connect the fixture wires to the house wires: black to black (live), white to white (neutral), and green or bare copper to ground. Use wire nuts and wrap with electrical tape for extra security. Tuck the wires neatly into the junction box. If your junction box has only two wires, the pendant may still work but will not be grounded – this is unsafe for outdoor use. Install a proper ground or call an electrician.
4. Attach the canopy and seal: Slide the canopy over the bracket and secure it with the screws. Apply a bead of silicone sealant around the top edge where the canopy meets the ceiling to block moisture. Tighten the screws evenly to avoid gaps. Do not overtighten – you can crack the canopy. Hand-tighten until snug, then check for a uniform seal.
5. Install the shade and ring: Screw the holder ring onto the pendant base, then attach the shade. For the Brooklyn pendant, you can choose between different ring finishes and holder finishes to match your décor. Ensure the shade is fully seated and the ring is hand-tightened. If the shade wobbles, the ring may be cross-threaded. Remove and re-thread carefully.
6. Restore power and test: Turn the circuit breaker back on and flip the light switch. The pendant should illuminate immediately. If it flickers or does not light, turn off power and re-check the wire connections. Flickering often indicates a loose neutral wire. Tighten the wire nut and test again.

Product spotlight

• Brooklyn Outdoor & Bathroom Pendant: The Brooklyn Outdoor & Bathroom Pendant is IP65 rated, designed for reliable performance in bathrooms, covered outdoor areas, and other environments requiring durable lighting. This means you can install it in a shower alcove or under a porch roof without worrying about moisture damage, as long as the electrical box is also weatherproof.