How to Install a Double Swivel Spotlight Flush Mount

By Industville Official - Modern, Retro, Industrial Lighting | Published: 2026-10-22

Category: How-to Guides

Install your double swivel spotlight flush mount safely and neatly with these step-by-step instructions, including wiring tips and common mistakes to avoid.

Quick answer

Installing the Swivel Spotlight Flush Mount – Double is a straightforward job if you follow the correct wiring and mounting sequence. This guide walks you through each step, from turning off the power to adjusting the adjustable swivel heads.

Before you start: what you need

You'll need a voltage tester, screwdriver, wire strippers, and the included mounting hardware. The Swivel Spotlight Flush Mount – Double comes in three finishes – Brass, Bronze, and Pewter – so choose the one that matches your decor. This unit can be mounted as a single wall light or a flush mounted ceiling light, but the steps here focus on the double wall light installation.

Safety first: power off and test

Turn off the circuit breaker supplying the junction box. Use a voltage tester to confirm there is no live current before touching any wires. This is the most common mistake – assuming the power is off without testing.

Step-by-step installation guide

1. Prepare the junction box: Ensure the junction box is securely fastened to the wall and can support the weight of the double spotlight. Remove any old fixture and disconnect wires. Check that the box is rated for the fixture weight.
2. Connect the wiring: Match the fixture wires to the house wires: black to black (live), white to white (neutral), and green or bare copper to ground. Use wire nuts and wrap with electrical tape. Tuck wires neatly into the box. Double-check polarity – reversed wires can cause a short.
3. Mount the base plate: Align the base plate over the junction box and secure it with the provided screws. Make sure it is level before tightening fully. A crooked base will make the swivel heads look uneven.
4. Attach the double spotlight unit: Position the double spotlight onto the base plate and fasten it with the included screws. Gently pull on the fixture to confirm it is secure. Overtightening can crack the metal housing – stop when snug.
5. Adjust the swivel heads: Loosen the swivel joint slightly, aim each head to your desired direction, then tighten. The adjustable head lets you put the spotlight on your focal features. Don't force the swivel past its range – it may damage the internal wiring.
6. Restore power and test: Turn the circuit breaker back on. Flip the wall switch and verify both bulbs light up. Adjust the heads again if needed while the light is on. If one head doesn't light, check the bulb or the wire connection inside that arm.

Product facts

Swivel Spotlight Flush Mount - Double: The Swivel Spotlight Flush Mount – Double features an adjustable swivel head that allows you to personalise how the light is dispersed. This means you can direct light exactly where you need it, whether illuminating artwork or a reading nook.
Swivel Spotlight Flush Mount - Double