How to Install a Bulb Holder on a Pendant Wire

Quick answer

To install a bulb holder on a pendant wire, strip the wire ends, connect them to the holder terminals matching polarity, and secure the holder cap. Always turn off the power first.

Step-by-step installation process

1. Step 1: Turn off the power and prepare the wire: Switch off the circuit breaker. Strip about 6mm of insulation from the end of the pendant wire using a wire stripper. Twist the exposed strands to prevent fraying. Common mistake: Not stripping enough insulation can cause a loose connection.
2. Step 2: Identify the terminals on the bulb holder: Unscrew the holder cap to reveal two terminals: one for the live (hot) wire and one for the neutral. The live terminal is usually marked with an L or a brass screw, the neutral with an N or a silver screw. Check: Ensure the holder cap is fully separated so you can work freely.
3. Step 3: Connect the wires to the holder: Loop the stripped wire ends clockwise around the terminal screws and tighten them securely. Connect the live wire to the live terminal and the neutral wire to the neutral terminal. Tug gently on each wire to confirm it's held. Common mistake: Wrapping counter-clockwise can loosen the connection when tightening.
4. Step 4: Secure the holder cap and test: Slide the holder cap over the connection and screw it onto the holder body until snug. Do not overtighten. Restore power and test the light with a bulb. Check: If the light flickers, turn off power and re-check the wire connections.

Product facts

• Noho Swan Neck Wall Holder - Brass: knurled detailing and a push-button switch The knurled texture provides grip when screwing, and the built-in switch lets you control the light without reaching a wall switch.